On my new DS there is a 9mm slot where the hub sits in to support the frame. Then the 5mm thruskew goes through that to secure it. I was worried if I used the hurricane components Reverve that it would bend the thruskew over time as it is not meant to support the frame, only secure tire to frame.
1 Comment
On my new DS there is a 9mm slot where the hub sits in to support the frame. Then the 5mm thruskew goes through that to secure it. I was worried if I used the hurricane components Reverve that it would bend the thruskew over time as it is not meant to support the frame, only secure tire to frame.
3d print can be found [HERE](https://www.printables.com/model/789269-9mm-hub-to-5mm-thru-axle-bike-fork-mount)
I used Carbon Fiber Nylon, but PETG should work fine. Possibly even PLA Plus.
Can buy the print in CF Nylon [HERE](https://waspengravings.etsy.com/listing/1688874137)
The mounting bracket used can be found [HERE](https://www.amazon.com/dp/B08W8PC31D?psc=1&ref=ppx_yo2ov_dt_b_product_details)
You will need your own hardware, bracket does not come with any.