Is this to far back? by ConsequenceLanky6580 Bicycle Bike Fixed Gear Fixed Gear Bicycle Fixed Gear Bike Single Speed Cycles
meehaja on April 16, 2023 7:47 pm Be reet, but you might want some chain tugs on there to ensure against slippage?
itmeterry on April 17, 2023 4:52 am it’s fine but you’ll need to put the chain on before you know where the wheel will actually land in the drop out
bell1975 on April 17, 2023 7:01 am Sweet as. I’ve had the axle nut only 2/3 covering the dropout and been ok…but it was done up VFT!
10 Comments
*too
Should be ok.
Is it a twenty two tooth? That would be too many teeth.
You have full engagement of the axle nut so it’s good to go.
You’re fine
If your chain has the appropriate tension/slack, then you’re fine.
Be reet, but you might want some chain tugs on there to ensure against slippage?
Not at all but I usually go as deep into the fork as possible
Nah, you are golden
it’s fine but you’ll need to put the chain on before you know where the wheel will actually land in the drop out
Sweet as.
I’ve had the axle nut only 2/3 covering the dropout and been ok…but it was done up VFT!