I tried truing my wheel. It is good enough?
I tried truing my wheel. It is good enough?
byu/noodlecat4 inbikewrench
by noodlecat4
I tried truing my wheel. It is good enough?
I tried truing my wheel. It is good enough?
byu/noodlecat4 inbikewrench
by noodlecat4
12 Comments
It looks uncentered and mostly true.
I’d say not. Got a hop and side to side action
No. It’s both out of round and out of true.
The hop happens at the same time as the pull, loosen that spoke half a turn.
Deep dish carbon rims usually build up pretty round, if you find that a little tweak here and there doesn’t work you should take it in and get the tension checked.
For gravel/road use you might want it a little bit more round
There’s I think two decent-sized deflections, I’d not be happy with that
Now you have egg shaped wheel
hell no bruh that’s terrible. You gotta be patient when truing your wheel and only make quarter turns to the spokes at a time. Also i’d recommend a white zip tie if you have one to contrast the wheel better.
if you’re asking yourself this question, answer is no
oval wheel
I’ve seen worse, but I have also seen better.
That is going to feel insane when it’s spinning fast. Being out radially is worse than being out laterally. Pretty much need to detention the whole wheel and start fresh.
You need to have even spoke tension, while keeping it round and straight. I’m guessing right now you have tight and loose spots.